Skip to main content
The damage diagram lets you record the condition of a vehicle when it arrives. Mark each dent or damaged area so the mechanic can see it on the printed job card.

Where to find it

Open a job from Workshop → Jobs. In the left column of the job editor, find the Tap to mark damage/dents card.

Mark damage

  1. Open the job and find the Tap to mark damage/dents card.
  2. Tap or click the diagram at the position of the damage. A red dot appears.
  3. Repeat for each damaged area.

The diagram depends on the vehicle

Eaglecart shows a diagram that matches the vehicle type. A car, an SUV and a bus each use their own diagram, so a bus looks different from a car. The diagram is not one generic image used for every vehicle.

Marker limit

You can place a maximum of 30 damage markers on a job. If you cannot add another marker, you have reached that limit.

Remove markers

Clear all dots removes every marker from the diagram. It is the confirmed way to remove markers. Check the diagram after using it, then place the markers you still need.

On the printed job card

The diagram and its damage markers print on the workshop job card, labelled “TAP TO MARK DAMAGE/DENTS”. See Print a workshop job card.
The diagram is an inspection record. It does not diagnose mechanical faults.

Troubleshooting

  • The diagram looks different for a bus. Diagrams follow the vehicle type.
  • I cannot add more markers. The limit is 30 per job. Use Clear all dots and re-mark only what you need.